Cisco Router Reset Password - Guide for Recover Cisco router Username and Password

Cisco Router Password Recovery: In case if you forgot the password of Cisco Router, its very easy to recover it. I recently got into an issue where i could not remember the enable password or enable secret set on the Cisco Router. I had to go into the Recovery Mode and through password recovery procedure was able to recover it successfully. This article will show you how you can gain full administrator access to a Cisco router, bypassing all security passwords. The password recovery process, however, can be rendered useless if the administrator has previously configured the router not to allow this process to take place. In this case, the router will warn the user and, if he proceeds, all configuration will be erased, so there will be nothing to recover!

How do you bypass a password on a Cisco router?

3) The trick is to bypass the startup-config which contains all the passwords. …
4) Set the confreg value to 0x2142.
5) reset the cisco router which will restart bypassing the startup-config.
6) Now you can see that Router> Prompt which started with Empty Configuration.
7) Use en to go to the enable / privilege mode.

How do I reset my Cisco router password without losing the configuration?

Reboot the router using the power switch. Press BREAK on the console terminal. When rommon>1 appears on the screen enter confreg 0x2142 comand to restart from the flash (This step skips the start-up configuration where the passwords are stored). Enter the RESET command when rommon2 > appears on the displa

How do I reset the password on my Cisco router 1841?

Please see the regular process to reset the password on 1841 Router below,
Connect the console cable to Router 1841.
Use the power switch in order to turn off the router, and then turn the router back on.
Press Break on the terminal keyboard within 60 seconds of power up in order to put the router into ROMMON.

Where is the Reset button on Cisco router?

Press the Reset button located at the back of the device with a pin for approximately 15 seconds or until the power light on the front of the device starts flashing. The Router reloads and is set to the default configuration settings.

How do I reset my Cisco 1700 router password?

Type confreg 0x2142 at the rommon 1> prompt in order to boot from Flash. This step bypasses the startup configuration where the passwords are stored. Type reset at the rommon 2> prompt. The router reboots, but ignores the saved configuration.

How do I reset my Cisco 1800 router to factory settings?

How to Factory Reset 1800 series Cisco router
Connect you PC to the router via console cable and connect using Putty.
Boot the router while holding ctrl and break get into rommon1>
Type the following command. …
Type Reset to start the factory reset. …
To enter config mode, issue the config terminal command.

How do I find my Cisco router username and password?

The IP address used for most Cisco routers is 192.168.

From the log-in page, enter your username and password. If you haven’t changed your default settings, type admin for username and Password for the code. (Note: Not all Cisco routers used this combination.) Hit the Ok button to access your web interface